Page 11 Paslode Cordless Fuel Cell Disposal Guidelines Paslode the industry leader in cordless technology provides this information to assist users with the proper disposal of discarded fuel cells. Acceptable disposal options vary depending on the type of fuel cell users. All users must consider federal, state and local solid waste regulations to ensure that discarded fuel cells are disposed of properly.
As shown in the illustration, this Cordless Framing Nailer is very simple. Five 5 nails will be left in the standards could cause tool damage and void your warranty. Page Fasteners And Applications Hardened Steel - For attaching wooden plates to green corosion resistance of any galvanized nail. Page Servicing Framing Nailer, clearing a jammed fastener is easy: 1. Remove the fuel cell and battery. Never attempt any maintenance of the Paslode Cordless 2. Lock follower back in magazine and remove fasteners.
Framing Nailer without first removing the fuel cell and 3. Page Troubleshooting Check lockout. If unable to free return tool to Lockout bracket is stuck in lockout position. Remove and inspect lower probe. Clean and Work-contacting element is bent, or build-up of lubricate track with Cordless Lubricating oil.
Page 19 If tool will not operate after following the above service directions, return the tool to an authorized Paslode. For factory direct service call For Tec hnical support call or visit our web site at www. Attempting to fire tool with a loose magazine will result in loss of nail control, damage to tool, 2.
If Battery does not appear to accept charge Inoperative indicator lights on charger, or tool LED is green, charger not working when the battery and charger is plugged defective charger. Adjust work contacting element. Fuel cell is low.
Check fuel cell and replace as required. There may be loss of seal in combustion Press work contacting element against chamber. Print page 1 Print document 22 pages. Rename the bookmark. Delete bookmark?
Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up! Restore password. Those using corded units can remedy the situation by connecting the air hose -the trigger should be pulled. The first thing you need to know is that Paslode nailers typically stay permanently green if its set up properly and running smooth. Side note: If it still continues to flash even after charging the battery fully, it may point to corroded battery contacts clean them then retry or a dying battery test it with a new battery.
There are a couple of possibilities here with the battery being the most probable culprit- you already know what to do. Most Paslode nail guns should be cleaned and lubricated after a given nunber of shots refer to your manual. Use the recommended Tune-up Kit for your model for the best results.
0コメント