Press and hold the button for the desire device for approximately six seconds. The top LED will turn on, enter pre-programmed code. LED will blink to indicate pre-programmed code was captured correctly. Page Aux Key Setup If user wants to control a Philips STB with a code under the AUX key, a 3 must be added in the beginning of the pre-programmed code making it AUX Button Nw Page 18 , , , , , , Nikko Noblex Olympus Optimus , , , , Optonica Orion , , Panasonic , , , , , , , , , , , , , , , , , Nw Page Installation TV system.
See page VGA 15 Pin Cable 7. Page Connecting With The Power Cord Connect the power cord to the AC inlet on the back of your LCD TV, after all connections have been completed, and plug the other end of the power cord into a correctly grounded electrical outlet.
There are several times for choice — OFF, 30min, 60min, 90min, or min. Page Tv Menu TV channels. Position: To adjust the horizontal position of the picture.
Position: To adjust the vertical position of the picture. Page Customer Support For technical support or product service, see the table below or contact your reseller. Note: You will need the product serial number. Print page 1 Print document 40 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up! Clean with a soft, dry cloth.
Do not block any ventilation openings. Install the equipment in accordance with the. Do not install near any heat sources such as radiators, heat registers, stoves, or other. Do not attempt to circumvent the safety provisions of the polarized or grounding-type.
A polarized plug has two blades with one wider than the other. A grounding type. The wide blade and the third prong are. Protect the power cord from being tread upon or pinched, particularly at the plug, and the.
Be sure that the power outlet is located near. Service is required when the unit has. This product is only to perform the useful function of entertainment and visual display tasks are excluded.
All rights reserved. Disclaimer:ViewSonic Corporation shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from furnishing this material, or the performance or use of this product.
In the interest of continuing product improvement, ViewSonic Corporation reserves the right to change product specifications without notice. Information in this document may change without notice. No part of this document may be copied, reproduced, or transmitted by any means, for any purpose without prior written permission from ViewSonic Corporation.
To meet your future needs, and to receive any additional product information as it becomes available, please register your product on the Internet at: www. ViewSonic is concerned about the preservation of our environment. Please dispose of this product properly at the end of its useful life. Your local waste disposal company may provide information about proper disposal. The lamp in this product contains mercury. Please dispose of properly in accordance with environmental laws of your location.
If an outside antenna or cable system is connected to the product be sure the antenna or cable system is. For added protection for this product during a lightning storm, or when it is left unattended and unused for.
This will. Do not disconnect the antenna or the. An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits, When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
Electric service equipment Ground clamps. Grounding conductors Power service grounding electrode system. Wipe the screen with a clean, soft, lint-free cloth.
This removes dust and other particles. If still not clean, apply a small amount of non-ammonia, non-alcohol based glass cleaner onto a clean, soft, lint-free cloth, and wipe the screen.
If still not clean, apply a small amount of a non-ammonia, non-alcohol based, mild non-abrasive detergent onto a clean, soft, lint-free cloth, then wipe the surface. ViewSonic will not be liable for damage resulting from use of any ammonia or alcohol-based cleaners.
Save the original box and all packing material for future shipping needs. Before installing the product to the wall, please consider the following guidelines:. This equipment is intended for indoor use only. Set the LCD TV on a table or work surface, screen-down with a towel or woolen blanket between the screen and the surface to protect the display. Through the matching screw holes in the bracket, there are 6 screws mounted on the backside of the LCD TV. Loosen all 6 screws, and keep for future use.
Use only approved wall-mounting brackets advised by ViewSonic or your local distributor. Volume Up. Headphone Jack. Note: Multiple pre-programmed codes are available for some devices; if default setting does not function, see pre-programmed table for additional codes. Welcome to ManualMachine. We have sent a verification link to to complete your registration.
Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. Contents Compliance Information ViewSonic Nw. Compliance Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
ViewSonic 1 Nw. Important Safety Instructions 1. Read these instructions completely before using the equipment. Keep these instructions in a safe place.
Heed all warnings. Follow all instructions. Do not attempt to circumvent the safety provisions of the polarized or grounding-type plug. A grounding type plug has two blades and a third grounding prong. The wide blade and the third prong are provided for your safety. Protect the power cord from being tread upon or pinched, particularly at the plug, and the point where if emerges from the equipment.
0コメント